the vehicle and the nozzle of the power
washer.
Information about the correct distance is
available from the equipment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
The water temperature of the power washer
must not exceed 140 ‡ (60 †).
!
Always maintain a distance of at least
12 in (30 cm) between the vehicle and the
power washer nozzle. Information about the
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
R
Tires
R
Door gaps, roof gaps, joints, etc.
R
Electrical components
R
Battery
R
Plug-type couplings
R
Light bulbs
R
Seals
R
Trim elements
R
Ventilation slots
Damaged seals or electrical components
can lead to leaks or failures.
Cleaning the paintwork
!
Do not affix:
R
stickers
R
films
R
magnetic plates or similar items
to painted surfaces. You could otherwise
damage the paintwork.
Scratches, corrosive deposits, areas affected
by corrosion and damage caused by inade-
quate care cannot always be completely
repaired. In such cases, visit a qualified spe-
cialist workshop.
X
Remove dirt immediately, where possible,
while avoiding rubbing too hard.
X
Soak insect remains with insect remover
and rinse off the treated areas afterwards.
X
Soak bird droppings with water and rinse off
the treated areas afterwards.
X
Remove tree resin, oils, fuels and greases by
rubbing gently with a cloth soaked in petro-
leum ether or lighter fluid
X
Remove coolant and brake fluid with a moist
cloth and clear water.
X
Use tar remover to remove tar stains.
X
Use silicone remover to remove wax.
If water no longer forms "beads" on the paint
surface, use the paint care products recom-
mended and approved by Mercedes-Benz. This
is the case approximately every three to five
months, depending on the climate conditions
and the care product used.
If dirt has penetrated the paint surface or if
the paint has become dull, the paint cleaner
recommended and approved by Mercedes-
Benz should be used.
Do not use these care products in the sun or
on the hood while the hood is hot.
X
Use a suitable touch-up stick, e.g. MB
Touch-Up Stick, to repair slight damage to
the paintwork quickly and provisionally.
Matte finish care
!
Never polish the vehicle or the light alloy
wheels. Polishing causes the finish to shine.
!
The following can give the paint a glossy
appearance and thus reduce the matt
effect:
R
Rubbing hard with unsuitable agents
R
Washing the vehicle in direct sunlight
!
Never use paint cleaner, buffing or polish-
ing products, or gloss preserver, e.g. wax,
for the purpose of paintwork care. These
products are only suitable for high-gloss sur-
faces. Their use on vehicles with matte
paintwork leads to considerable surface
damage or, more specifically, to shiny, spot-
ted areas.
Always have paintwork repairs carried out at
a qualified specialist workshop.
!
Only use automatic car washes which cor-
respond to the latest technological stand-
ards. Never use wash programs which finish
by treating the vehicle with hot wax.
Observe these notes if your vehicle has a clear
matte finish. This will help you to avoid dam-
age to the paintwork due to incorrect treat-
ment.
280
Care
Maintenance and care
To Next Page
Loading...
Need help?
General
