Operating the combination light switch
1
High beam
2
Right turn signal light
3
Headlamp ashing
4
Le tur
n signal light
#
Use the combination switch to select the
desir
ed function.
Switching on high beam
#
Switch on the low beam (/ page 84).
#
Push the combination switch forwards 1.
The K indicat
or lamp on the instrument
cluster will light up. The combination switch
will return to its starting position.
%
In the à position, t
he high beam switches
on only in darkness and when the vehicle is
switched on.
#
To switch o: push t
he combination switch for-
wards 1 or briey pull it in the direction of
arrow 3 (the action for headlamp ashing
switches high beam o).
The K indicator lamp on the instrument
cluster will go out. The combination switch will
return to its starting position.
%
Vehicles with Highbeam Assist: when High-
beam Assis
t is active, it controls the activation
and deactivation of the high beam
(/ page 86).
Headlamp ashing
#
Briey pull t
he combination switch in the direc-
tion of arrow 3.
Turn signal light
#
To indicate: push t
he combination switch in the
required direction 2 or 4 until it engages.
When signicant s
teering movements are
made, the combination switch will automati-
cally reset itself.
#
To indicate br
iey: tap the combination switch
briey in the required direction 2 or 4. The
corresponding turn signal lamp will ash three
times.
Switching the hazard warning light system on/o
#
Press button 1.
If you operate a turn signal indicator while the haz-
ar
d warning light system is switched on, only the
turn signal lamps on the relevant side of the vehi-
cle will light up.
%
The hazard warning light system will work even
when t
he vehicle has been switched o.
Cornering light function
The cornering light improves the illumination of the
r
oadway over a wide angle in the turning direction,
e.g. enabling better visibility in tight bends.
Light and vision
85
To Next Page
Loading...
Need help?
General
