ON THE WATER
SECTION 3
Page 30 CMD-3967823 / 90-865237030 OCTOBER 2003
CE483
SHIFTING
CAUTION
Never attempt to shift the transmission unless the engine is at IDLE rpm. Damage
to the transmission could occur.
1. To shift unit, ensure remote control/throttle lever is in NEUTRAL. Move control/shift lever
forward to shift to FORWARD gear, or backward to shift to REVERSE. After shifting the
transmission, advance the throttle to the desired setting.
2. Once underway, engine oil pressure should be within the range listed in the engine
specifications chart at maximum rpm, or wide-open-throttle. Stop the engine if oil
pressure is not within this range. Locate and correct the problem, or see your authorized
Cummins MerCruiser Diesel dealer / distributor if you are unable to determine the
problem.
CE484
ENGINE SHUTDOWN (STOPPING)
1. Place remote control lever in NEUTRAL.
CAUTION
Avoid damaging the turbocharger and engine. Immediate engine shutdown
(stopping) after high load operation may result in permanent turbocharger bearing
damage. Operate the engine at IDLE for several minutes before shutdown.
2. Operate the engine at idle speed for several minutes to allow the turbocharger and
engine to cool.
3. Engage the STOP switch and hold, until the engine shutsdown (stops) completely.
4. Turn key switch to the OFF position.
To Next Page
Loading...
Need help?
General