STORAGE
SECTION 6
CMD-3967823 / 90-865237030 OCTOBER 2003 Page 97
CE502
Power Package Recommissioning
NOTICE
Refer to Cold Weather Or Extended Storage precautions, BEFORE proceeding.
1. Install the seawater pump impeller after ensuring that the splines are not worn and
inspecting it for worn or damaged vanes.
a. Remove the seawater pump cover mounting screws.
b. Remove the seawater pump cover and O-ring.
c. Install the seawater pump impeller into the housing by turning clockwise while simul-
taneously pushing inward.
d. Install a new O-ring on the seawater pump.
e. Install the seawater pump cover.
f. Install the seawater pump cover mounting screws. Tighten the screws evenly in a
diagonal pattern. Tighten the screws securely.
79743
a
b
d
b
79742
c
a-Mounting screw (4)
b-Cover
c-Impeller
d-O-ring
2. Ensure that all cooling system hoses are in good condition, connected properly, and
hose clamps are tight.
3. Verify that all drain valves and drain plugs are installed and tight.
4. Inspect all drive belts.
To Next Page
Loading...
Need help?
General