!
WARNING
Failure to properly secure the battery leads can result in a loss of power to
the Digital Throttle and Shift (DTS) system, leading to serious injury or death
due to loss of boat control. Secure the battery leads to the battery posts with
hex nuts to avoid loose connections.
Description Nm lb‑in. lb‑ft
Hex nuts 13.5 120 –
IMPORTANT: Battery cable size and length is critical. Refer to Battery Cable
Size tables or engine installation manual for size requirements.
A decal advising against using deep cycle batteries and wing nuts should be
placed on or near the battery box for future service reference. One 5/16 in. and
one 3/8 in. hex nut is supplied per battery for wing nut replacement. Metric hex
nuts are not supplied.
54395
Place decal on or near battery box for future
service reference. Included with the engine
rigging components are 5/16" and 3/8” hex
nuts to be used for battery terminal wing nut
replacement. Metric hex nuts must be obtained
locally.
8M0085862
Refer to the outboard owner’s manual for
battery requirements.
Battery cable size and length is critical.
Refer to engine installation manual for
size requirements.
NOTICE
IMPORTANT:
DO NOT USE DEEP CYCLE BATTERIES!
13.5Nm (120 lb-in.)
DO NOT
USE
WINGNUTS
Air Filter (200–300)
The air filter assembly is a serviceable item and can be cleaned with
warm soapy water if required.
AIR FILTER REMOVAL AND CLEANING
1. Loosen air filter clamp screw.
MAINTENANCE
eng 91
To Next Page
Loading...
Need help?
General
