Checking Power Steering Fluid
Remove power steering cover and fill cap to check fluid level. The fluid level
should be slightly below the bottom of the fill hole. Use SAE 0W‑30 synthetic
power steering fluid, if needed.
a - Power steering cover
b - Fill cap
c - Fill/full level
Tube Ref
No.
Description Where Used Part No.
138
Synthetic Power
Steering Fluid SAE
0W-30
Power steering system 92-858077K01
Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacity is approximately 7.0 Liter (7.4 US qt).
PUMP METHOD
IMPORTANT: Tilt the outboard out/up past vertical for approximately one
minute to allow any trapped oil to drain back to the oil sump.
IMPORTANT: To reduce or prevent oil spillage when removing the oil filter,
ensure that the outboard is upright (not tilted) and the engine is cold or has not
run for at least one hour.
IMPORTANT: The pump method is preferred to remove engine oil from XXL
models. If the drain method is used, an oil drain funnel must be used to divert
oil from the lower splash plate and into the container.
1. Tilt the outboard out/up past vertical for approximately one minute to allow
any trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
To Next Page
Loading...
Need help?
General
