Section 2 - On the Water
CMD-4082082 / 90-8M0052072 eng FEBRUARY 2011 Page 39
IMPORTANT: The boat's stopping distance increases during manual gear engagement operation.
Transporting an Axius Boat
The drives on an Axius boat are not connected by a tie bar, and can be moved independently by gravity and the vibrations of
traveling, making it possible for the drives to contact each other.
Avoid the possibility of the drives making contact during travel:
1. Remove the propellers (optional on short moves).
2. Put the drives in the full‑up, trailer position.
3. Push each drive out towards the side of the boat, past the straight ahead position.
When trimmed up and pushed outward, the drives will move away from each other if they move.
Boat on trailer, drives trimmed up and pushed outward
To Next Page
Loading...
Need help?
General
