Section 2 - On the Water
CMD-4082082 / 90-8M0052072 eng FEBRUARY 2011 Page 37
7. Press the enter button to acknowledge the you understand it is OK to turn. The enter button is in the upper right corner of
VesselView and has a check mark symbol.
Waypoint acknowledge screen
8. Stay alert; the boat turns automatically in this mode. The operator must know if it is safe to turn when the vessel is entering
a waypoint arrival zone. Inform passengers that the boat automatically turns so they can be prepared.
9. Press "WAYPOINT SEQUENCE" button when not in a waypoint arrival zone to disable Auto‑Sequence mode.
10. Press the "TRACK WAYPOINT" button a second time to put Precision Pilot in Standby mode. All lights other than "STANDBY"
turn off.
27701
"TRACK WAYPOINT" mode button
Cruise Control
The VesselView system features integrated throttle Cruise Control (Cruise), which allows the operator to limit the peak RPM of
choice below Wide Open Throttle (WOT). This feature requires VesselView. Refer to the owner's manual provided with your
VesselView for operation instructions.
These additional notes are exclusive to your Axius Premier package:
• You can change or disengage Cruise through the screen at any time.
• Cruise resets when the key is turned off.
• If the Cruise limit is changed while the levers are at WOT, Cruise gradually changes to the new speed.
• Cruise does not disengage if the ERC levers are at a higher engine speed than the actual RPM. Bring the levers back to the
forward detent to disengage.
To Next Page
Loading...
Need help?
General
