Settings
112
Remote control
This menu option will only be dis-
played if you have connected your
dishwasher to your WiFi network (see
“Settings” chapter, “Miele@home”
section)
If you wish to permanently switch off
the Remote controloption, you can do
this under this menu option. The
sensor control will then no longer be
available to select until you change this
setting again.
Even if the Remote controloption is
switched off, you can use Miele@mobile
to call up information about your appli-
ance. However, you cannot start any
programmes or change any settings
from it.
RemoteUpdate
The RemoteUpdate menu option is
only displayed and can only be selec-
ted if the requirements for using
Miele@home have been met (see “Be-
fore using for the first time” chapter,
“Miele@home” section).
The RemoteUpdate function is used for
updating the software in your dish-
washer. If an update is available for
your dishwasher, it will automatically
download it. Updates will not be in-
stalled automatically. They must be initi-
ated manually.
If you do not install an update, you can
continue to use your dishwasher as
usual. However, Miele recommends in-
stalling updates.
Activating/deactivating
The RemoteUpdate function is activ-
ated as standard. Available updates will
be downloaded automatically and will
only be installed if you initiate them.
Deactivate RemoteUpdate if you do not
wish any updates to be downloaded
automatically.
To Next Page
Loading...
Need help?
General
