Miele G7360 SCVi User Manual

Problem solving guide
84
Fault in the AutoDos (automatic dispensing)
Problem Cause and remedy
The message
Insert PowerDisk or deactiv-
ate AutoDos with OK ap-
pears in the display.
The AutoDosfunction is active but no PowerDisk
has been inserted.
 Insert a PowerDisk (see the “Detergent” chapter,
“Automatic dispensing/AutoDos” section).
 If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dossensor control.
The optical in-operation
indicator light is flash-
ing quickly.
The alarm tone is
sounding.
The programme does
not start or a pro-
gramme that has
already started stops.
The messageAutoDos lid
open appears in the dis-
play
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see “Deter-
gent” chapter, “Automatic dispensing/AutoDos”
section).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergent”
chapter, “Inserting a PowerDisk” section).
 If the same fault message appears again, call the
Miele Customer Service Department.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display.
The AutoDosfunction is active and the PowerDisk
is empty.
 Replace the PowerDisk (see the “Detergent”
chapter, “Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dossensor control.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display
even though you have
inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not re-
cognised the new PowerDisk.
 Switch the dishwasher on before replacing the
PowerDisk (see the “Detergent” chapter, “Auto-
matic dispensing/AutoDos”, “Inserting a
PowerDisk” section).

Miele G7360 SCVi Specifications

General

Brand	Miele
Model	G7360 SCVi
Category	Dishwasher
Language	English