Dismantling the door
The door is sealed all round to prevent
air in the oven cavity from getting into it.
In the unlikely event that soiling has
worked its way in between the glass
panes, the door can be dismantled in
order to clean in between the panes.
Take particular care as scratches
can damage the glass.
When cleaning the glass panes do
not use abrasive cleaning agents,
hard sponges or brushes and do not
use sharp metal tools or scrapers.
Please also read the general notes
on cleaning the oven front before
cleaning the glass panes.
Oven spray will damage the
aluminium trims inside the door.
These should only be cleaned using
hot water and washing-up liquid
applied with a clean sponge or a
clean, damp microfibre cloth.
Be especially vigilant after
dismantling the door that the glass
panes do not break.
,
Danger of injury.
Always remove the door before
dismantling it.
^
Place the door on a protective
surface (e.g. on a tea towel) to
prevent it getting scratched. The
door handle should line up with the
edge of the table. Make sure the
glass lies flat and does not get
broken during cleaning.
^
Unscrew the Torx screws and then
pull the guides and the trim together
with the seal off.
You can now remove the inner and
middle panes.
Cleaning and care
78
To Next Page
Loading...
Need help?
General
