,
The cooker must not be
operated until it has been correctly
installed in its housing unit.
In order to function correctly, the
cooker requires an adequate supply
of cool air.
Ensure that the supply of cool air is
not impaired (e. g. by heat insulation
strips in the housing unit).
Please also ensure that the cool air
supply is not unduly heated by other
heat sources such as a wood
burning stove.
Before installation
^ Before connecting the appliance to
the mains, you must disconnect the
power supply to the isolator switch.
^ Follow the connection diagram
supplied with the cooker.
Installing the cooker
^
Connect the mains cable from the
cooker to the isolator.
^
Align the cooker in front of the base
unit.
^
Connect the hob plugs to the socket
on the cooker.
Lifting the oven by the door handle
can damage the door. Use the
handle recesses on the side of the
casing.
It is advisable to dismantle the door
before installing the appliance (see
"Cleaning and Care - Dismantling the
door") and remove accessories from
the oven cavity. This will make it easier
to install in its niche and you will not be
tempted into using the handle to carry
it.
^
Push the cooker into the base unit
and align it.
^
Open the door (if you have not
removed it previously).
^
Use the screws supplied to secure
the cooker to the side walls of the
housing unit through the holes in the
trim.
^
Refit the door, if necessary (see
"Cleaning and care - Refitting the
door").
Built-in cooker
94
To Next Page
Loading...
Need help?
General
