Opening and closing the door
26
Opening the door using the emergency release
The emergency release should only be operated when it is no
longer possible to open the door in the usual way.
If the emergency release is operated during a programme
sequence, hot water can escape.
Danger of scalding and burning.
The emergency release mechanism is located on the right beside the
door lock in the gap between the door and the lid of the machine (or
the countertop, with built-under machines).
The emergency release is operated using the tool supplied in the
accessory pack together with the operating instructions.
Insert the tool for the emergency release into the gap between the
lid and the door to the right of the lock. The right-hand edge of the
tool should ideally be aligned with the right-hand edge of the
display.
Push the slider for the emergency release backwards with the tool
until the door opens slightly.
If you push against the door of the commercial dishwasher at the
same time, less force will be needed to operate the emergency
release.
When the door has been opened using the emergency release, the
following message will appear in the display:
Emergency release -
Door opened
The message is confirmed when the door has been released from the
closing mechanism. The last programme used will then appear in the
display.
To Next Page
Loading...
Need help?
General
