Adding rinsing agent
34
Adding rinsing agent
Open the door fully.
Unscrew the lid of the rinsing agent container.
Add rinsing agent only until it is up to the maximum mark on the
edge of the funnel on the container.
The container holds approx. 300ml.
Screw the lid of the rinsing agent container back on tightly so that
water cannot get into the container during the wash cycle.
Run the “Cold” programme to rinse away any spilled rinsing agent.
This prevents over-foaming occurring during the next programme.
You can adjust the dispensing quantity of the rinsing agent for best
results (see “Additional settings, Additional functions”).
To Next Page
Loading...
Need help?
General
