Venting the Dos. system
The Dos. system will not dispense
reliably if there is air in the system.
The Dos. system must be vented
–
if it is being used for the first time,
–
if the liquid detergent reservoir was
not refilled on time and the Dos.
system was sucked empty.
,
To ensure that the Dos. system
functions properly, prior to venting
make sure that the detergent
container is full enough and that the
dispensing lances are firmly
attached to the containers.
^ Select
Start venting and press the
centre button to confirm.
The venting process begins. The
remaining time appears in the display.
The Pre-rinse program is offered
directly after the venting process is
finished. Start the program in order to
dilute and drain any detergent that
escaped into the wash cabinet.
High temp rinse
For better drying, the rinse temperature
can be increased. This function is not
available for all programs (see Program
guide).
^
Select the desired setting and press
the centre button to confirm.
Water plus
When selected, more water will be used
for the wash cycle. This function is not
available for all programs (see Program
guide).
^ Select the desired setting and press
the centre button to confirm.
Preselect progr
You can chose whether to preset the
Normal program or the last selected
program when the commercial
dishwasher is switched on.
^ Select the desired setting and press
the centre button to confirm.
Settings menu
78
To Next Page
Loading...
Need help?
General
