Showroom program
Demo mode for showrooms only!
The commercial dishwasher is
equipped with various demo programs.
–
Demo with sound:
This program activates the pumps to
demonstrate the sound of the
dishwasher washing (without water).
–
Demo AutoOpen:
The door will open automatically.
To switch Demo mode on
^ Select the desired option.
^ Select
On and press the centre
button to confirm.
^ Close the Settings menu.
^ Press the Start/Stop button.
The Demo begins.
To switch Demo mode off
Demo mode ends automatically after
one cycle.
Factory default
If you have changed any settings from
the factory default, you can reset them
back to the factory default settings. An
activated external dispensing module
and its respective amount of detergent
or dosage concentration will not be
reset.
^
Select
Reset to default and press
the centre button to confirm.
Select last program
You can chose whether to preset the
Normal program or the last selected
program when the commercial
dishwasher is switched on.
^
Select the desired setting and press
the centre button to confirm.
Temp. display
During a program the current
temperature is displayed as factory
default setting.
If the temperature display is turned off
the remaining run time is being
displayed during a program.
^ Select the desired setting and press
the centre button to confirm.
Temperature
The temperature can be displayed
either in degrees Celsius (°C) or
degrees Fahrenheit (°F).
^
Select the desired setting and press
the centre button to confirm.
To close the Settings menu
You can close the Settings menu with
Close.
^
Select
Close and press the centre
button to confirm.
The last selected program is displayed
briefly and the respective indicator light
comes on.
After a short while, the estimated
program runtime is displayed.
Settings menu
79
To Next Page
Loading...
Need help?
General
