Starting the descaling process
As soon as the intake process E0
has been started, the descaling
process can no longer be
cancelled.
F Select the Moisture Plus d function.
G Use the rotary selector to select E.
H Touch the OK sensor.
If the Moisture Plus d function was
already locked, the descaling
process can be started immediately
by touching the OK sensor.
The prompt for the drawing in process
(E0) will appear and the triangle V will
flash under ?.
?
Eo
;
I Touch the OK sensor.
The intake process will begin. You can
hear the pump while this is happening.
The amount of solution specified may
be more than the amount which is
actually taken in. Some of the solution
may therefore be left in the container at
the end of descaling.
The activation phase (Ei) will begin.
You can follow the duration as it counts
down.
:i
:
20
h
F
T
J Open the door.
K Leave the container with the tube
connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
L Close the door.
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump for a
moment or so.
The descaling step can be displayed:
^
Touch X.
^
Use the rotary selector to select 6.
Ei
F
6T
;
^
To display the time remaining, use
the rotary selector to move the
triangle V until it is under T.
At the end of the activation phase a
buzzer will sound three times if the
buzzer is switched on (see "Settings –
P2").
Cleaning and care
104
To Next Page
Loading...
Need help?
General
