Preparing and starting the water
intake process
The prompt for the water intake process
will appear. The triangle V will flash
under ?.
?
;
^
Open the door.
^
Pull the water intake pipe forwards
(located below the control panel on
the left).
^
Immerse the end of the water intake
pipe in the container with tap water.
^
Touch the OK sensor.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
The intake process can be interrupted
and restarted at any time by touching
OK.
^
Remove the water container after the
water intake process.
^
Close the door.
You will hear the pump briefly as the
remaining water in the water intake pipe
is drawn into the oven.
The appliance begins to heat up.
The current temperature and the
temperature indicator light 3 will
appear.
3
92
°C
You will see the temperature
increasing.
A buzzer will sound when the oven
temperature is reached if this option is
selected (see "Settings P2").
Moisture Plus d
57
To Next Page
Loading...
Need help?
General
