Before using the machine for the first
time ensure that it is correctly
installed and connected. See
"Installation and connection". Also
check that the drain filter is securely
tightened to prevent the risk of water
leaks during use.
The washer-dryer has a sensor which
measures the amount of laundry in the
drum. This determines the amount of
detergent required. To allow the load
size indicator to function correctly, you
must first run a wash programme
without any laundry
and without
detergent.
^ Open the stopcock.
^ Press the
I-On/0-Off
button in.
If the washer-dryer is being switched on
for the first time, the welcome screen
will appear.
M
Willkommen
The welcome screen will not appear
again once a programme lasting
longer than 1 hour has been
completed.
After a few seconds the display will
change to show the screen for
selecting your language.
Setting the language
C èeština
F dansk
deutsch
H
^
Use the – and + buttons to select the
language you want and confirm your
selection by pressing the OK button.
Setting the time of day
The display for setting the time will
appear.
12:00
Set the time
^ Set the hour with the – and + buttons
and confirm your setting by pressing
the OK button. Now set the minutes.
After you have confirmed the minute
setting, the display will change to
show the reminder to remove the
transport struts.
Before using for the first time
12
To Next Page
Loading...
Need help?
General
