^
Fit the covers on to the two holes.
Then plug the holes as shown with
the caps.
,
The machine must not be moved
without the transit bars in place.
Store them in a safe place for future
use. They must be re-fitted if the
machine is to be moved again (e.g.
when moving house).
Re-fitting the transit bars
Re-fitting is carried out by reversing the
procedure.
Levelling the machine
The machine must stand perfectly level
on all four feet to ensure safe and
proper operation.
The four adjustable screw feet are used
to level the machine. All four feet are
screwed in when the machine is
delivered.
^
Using the spanner supplied turn
counter nut 2 in a clockwise
direction. Then turn counter nut 2
together with foot 1 to unscrew.
^ Use a spirit level to check the
machine is standing level.
^ Hold foot 1 securely with a pipe
wrench. Turn counter nut 2 again
using the spanner supplied until it
sits firmly up against the housing.
All four counternuts must sit firmly
up against the housing. Please also
check this for the feet which did not
need adjustment. Otherwise there is
the danger of the machine moving
about.
Installation and connection
64
To Next Page
Loading...
Need help?
General
