Reminder to remove transport struts
To avoid the risk of damage, the
transport struts must be removed
before the washer-dryer is used for
the first time. See "Installation and
connection" for instructions on how
to do this.
i
Remove transport
struts
OK
^
After removing the transport struts (if
this has not already been done by
your fitter) press the OK button.
Running your first programme
Your washer-dryer is now ready for the
first programme to be run.
15:00
Select programme
^
Turn the programme selector to the
Cottons
position.
^
Press the
Start/Stop
button.
^
When the programme has finished,
turn the programme selector to
Stop
and switch off the washer-dryer.
The load sensor must then be
calibrated to zero as you would with
bathroom scales.
Calibrating the load size sensor to
zero
^
Switch the machine on.
^
Open the drum door.
^
Turn the programme selector to the
Cottons
position.
^
Press and hold the
Load/Detergent
button pressed in until the following
message appears in the display:
i
Zero setting
OK
^ Turn the programme selector to
Stop
and switch off the washer-dryer.
The machine is now ready for use.
Before using for the first time
13
To Next Page
Loading...
Need help?
General
