Building under a continous
worktop / in a kitchen run
N = Niche height (820-930 mm)
This machine is specially designed for
installation under a continuous worktop
run in a fitted kitchen.
It is supplied with a cover plate
instead of a machine lid.
The cover plate is necessary to
ensure electrical safety and must not
be removed.
The machine must not be used
without the front panel in place.
–
The slides supplied should be used
to protect the floor from damage
when the machine is pushed into
position or taken out for servicing.
– Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Niche height Accessory
820 mm None required
from 830 - 840
mm
Fit longer screw feet*
(Set to approx.
40 mm)
from 870 - 885
mm
Use one raising kit*
from 915 - 930
mm
Use two raising kits*
* optional accessory
If the kitchen run has a continuous
furniture plinth in place, a gap must
be made for the washer-dryer.
Installation and connection
65
To Next Page
Loading...
Need help?
General
