Command Mode - Configuration & Operation
24
SIA protocol is 6 and for contact ID protocol is 4. For SIA protocol the allowed digits are simple 0 to 9 while for
contact ID the hexadecimal digits are used i.e. fro 0-9 and A to F. To enter hexadecimal digits, press the INFO
button. The letter “A” will appear press the INFO key again to scroll through the rest of the letters, to move the cursor
forward press # or press * to move it backward. The default account ID is “123456”
Configuration Menu/Dialer Config/Account Info/2. Account#1 Telnum
Sets the telephone number of the monitoring station, the maximum # of digits allowed is 19 including “,” and
numerals. The “,” will be treated as 1 sec delay. To enter ‘,’ press MENU key, to mov
e the cursor forward use ‘#’ key
and
to move the cursor backward use the ‘*’ key. An example of a typical telephone # is 9,,1234567. The default
phone number is “101”
Configuration Menu/Dialer Config/Account Info/3. Account#1 format
Set the reporting format that is recognized or preferred by the monitoring station.
Configuration Menu/Dialer Config/Account Info/4. Account#2 ID
Set the Account ID for the monitoring station to which the dialer reports events, the maximum # of digits allowed for
SIA protocol is 6 and for contact ID protocol is 4. For SIA protocol the allowed digits are simple 0 to 9 while for
contact ID the hexadecimal digits are used i.e. fro 0-9 and A to F. To enter hexadecimal digits, press the INFO
button. The letter “A” will appear press the INFO key again to scroll through the rest of the letters, to move the cursor
forward press # or press * to move it backward. The default account ID is “123456”
Configuration Menu/Dialer Config/Account Info/5. Account#2 Telnum
Sets the telephone number of the monitoring station, the maximum # of digits allowed is 19 including “,” and
numerals. The “,” will be treated as 1 sec delay. To enter ‘,’ press MENU key, to mov
e the cursor forward use ‘#’ key
and
to move the cursor backward use the ‘*’ key. An example of a typical telephone # is 9,,1234567. The default
phone number is “101”
Configuration Menu/Dialer Config/Account Info/6. Account#2 format
Set the reporting format that is recognized or preferred by the monitoring station.
Account #1 Telnum :
101
$FFQW IRUPDW
>;@&RQWDFW,'
>@ 6,$ EDXG
>@ 6,$ EDXG
$FFRXQW ,'
$FFRXQW 7HOQXP
$FFQW IRUPDW
>;@&RQWDFW,'
>@ 6,$ EDXG
>@ 6,$ EDXG
To Next Page
Loading...
Need help?
General
