Command Mode - Configuration & Operation
30
OPERATION MENU/3. REPORTS
Reports can be displayed on the shared display for the following items
Operation Menu/Reports/1. Alarm log
The alarm logs are displayed in the above format, pressing the INFO key shows additional information about the
log.
Operation Menu/Reports/2. Event logs
Event log(s) has the same format as alarm log
Operation Menu/Reports/3. Current level
The user is prompted to enter the loop no of the device to which it is connected.
The current level and the percentage alarm is shown in the following format.
The user can press UP and DOWN key to scroll through all the analog devices on the loop. If there are no analog
devices on the loop the following message will be displayed.
Operation Menu/Reports/4. Verify counts
The user is prompted to enter the loop no of the device to which it is connected.
The verify count is shown in the following format.
Re-enter password
__________
Report Menu
1. Alarm Log
2. Event Log
3. Current levels
4. Verif Counts
5. Maint Report
Nverf alm ipt
Active 002/016
Lp:1 Addr:002
Jul 20, 2005 09 :25AM
Loop Number
Loop :__
Lp:1 Addr :001
Levl :0024 Alarm :000%
No analog devices
found
Loop Number
Loop :__
Lp:1 Addr :001
Verify count :000
To Next Page
Loading...
Need help?
General
