FX-350/351 Series Programming Manual
29
Multiple day holidays can also be entered by entering the appropriate start and end date.
OPERATION MENU
The operation menu is divided into the following sub menu items
The “8. Test Dialer” menu will only appear if there is a UDACT on-board.
OPERATION MENU/1. SET TIME
Set the current date and time for the panel. Use the ‘#’ key to move the cursor forward and the UP and DOWN key
to change the date/time parameters.
OPERATION MENU/2. SET PASSWORD
This menu is used to set the password for all three access levels. For changing a specific level of password the
password required is the equivalent level or higher level.
The user is prompted to enter the access level for which the password needs to be changed.
The user is then prompted to enter the current access level or higher level password. The maximum number of
digits allowed is 10.
If the password is not right the user is given three chances to enter the correct password and during this time an
invalid password message is display to prompt the user the password is not right. After the three failed tries the
display falls back to the main operation menu.
If the password is right the user is prompted to enter the new password.
To confirm the password the user is prompted to re-enter the password again
Every year ?
[X] Enable
2SHUDWLRQ0HQX
6HW7LPH
6HWSDVVZRUG
5HSRUWV
&OHDUORJV
:DONWHVW
%\SDVV
$X[GLVF
7HVW'LDOHU
$IWHUKRXUV
&OHDUYHULFQWV
([LW
Date : Oct 08, 2005
Time : 10:00 PM
Access Level :1
Enter password
__________
Invalid password
Enter new password
__________
To Next Page
Loading...
Need help?
General
