FX-350/351 Series Programming Manual
37
By pressing the INFO key gives the following additional information
The first line show the loop# and the address, the second line shows the date and time when the event has
occurred.
Other events are displayed in the same format with information applicable to that event only.
General Event Log
The general event log report displays the contents of the general event log on the shared display which contains the
last 400 of any of the following events:
• activations of any input circuits
• restorals of non-latching input circuits
• pre-alarm on any device
• initiation of the alarm verification sequence on a verified alarm input
• any system troubles
• activation of any system common control or any command on the command menu
The report format is similar to the alarm log report.
Current Levels Report
The current levels report displays the current alarm level for analog devices on the specified loop as a percent of
alarm as well as its current raw analog reading.
The display shows the loop#, device address, current level and the %alarm in the following format:
If no analog devices are found on the specified loop(s), a message is displayed to that effect.
Verification Count Report
The verification count report displays the number of times that the alarm verification cycle has been initiated without
causing an alarm for all verified device or circuits on the specified loop or loops. If the count is zero, the device is
not displayed.
The report shows the loop#, device address and count in the following format:
If no verified devices with a non-zero counter are found on the specified loop(s), a message is displayed to that
effect.
Verification counters are cleared by the clear verification count command and at initial power-up.
Maintenance Report
The maintenance report displays all detectors on the specified loop or loops that are currently reading dirty or
almost dirty. Almost dirty is defined as more than 75% of the dirty level. Dirty detectors are displayed first followed
by the almost dirty. The two parts are separated by a sub heading.
The report shows the device address, percentage dirty, device type, and programmed message in the following
format:
If no dirty or almost dirty devices are found on the specified loop(s), a message is displayed to that effect.
Lp:1 Addr:002
Jul 20, 2005 09 :25AM
Lp:1 Addr :001
Levl :0024 Alarm :000%
Lp:1 Addr :001
Verify count :000
Maint Report
Percent dirty :012%
To Next Page
Loading...
Need help?
General
