1.1.3
SF-TL card
(1) Rotary switch
Name Description
CSl
Axis number setting rotary switch.
(2) Volume
(Note) After the bare board drawing number G52, VRl is
not provided.
Name Description
VRl
Sensitivity of magnesensor
(3) Setting pins
No.
Name
Setting
Description
1'1\1
I
Outputs an encoder feedback signal
,'I\?
from CONB to CONAA.
PIN1
CONAA
PIN2
output
The bare
selection
/
2
!
Outputs a feedback signal from the
board
draw-
1'11
I
CON2 motor detector to CONAA.
ing
No-G52
i,,\:
does not
However,
the phase Z outputs the
provide
PIN1 and
linear zone of the magnesensor.
PIN2.1
Outputs a feedback signal from the
CON2 motor detector to CONAA.
For normal operation, 1 and 2
should be shortcircuited.
When the
pin is removed from the positions 1
PIN4
Test pin
!'1\1
and 2 and then it is inserted into
positions 3 and 4, ignores an emer-
gency stop signal from the bus
linkage cable.
.
.
(’
Continuea on tne next page.
-180-
To Next Page
Loading...
Need help?
General