Mitsubishi FREQROL-SF User Manual

1.3.3
An alarm appears on the display on the
board (SF-CA card) of the amplifier.
As an example:
1-e ,
8-1 ,_ c
, I-
,
3
Alternatively,
an alarm appears on the
As an example: Spindle alarm 15 32
printed circuit
NC CRT.
The contents of the alarm which appears on the spindle
amplifier are the same as those which appear on the NC
CRT.
The contents of alarms are listed in the following table.
The details of each alarm are described in the following.
(Note) If the alarm No.12 (MEl) memory error 1 occurs,
it should be reset by turning off the power of
the spindle amplifier.
On the other hand, other alarm Nos. should be
reset by turning off the NC power.
- 20 -

Mitsubishi FREQROL-SF Specifications

General

Brand	Mitsubishi
Model	FREQROL-SF
Category	DC Drives
Language	English