1.2
Setting parameters
When driving a machine using the spindle motor, it is
necessary to determine parameters so that the perform-
ance of the machine can be maximized in accordance with
the machine specifications and motor characteristics.
Because the contents of the parameters just depend on the
machine to be used,
refer to the parameter list provided
by the machine manufacturer. The parameters are set using
the display and set switches on the SF-CA card.
On the
other hand,
when the equipment 'is linked with the machine
through the bus line,
part of parameters can be set from
the NC.
(Parameters
#21
to
#40
are set from the NC CRT.)
(Note) When changing parameters, it is necessary to change
those on the parameter list at the same time.
-182-
To Next Page
Loading...
Need help?
General