Mitsubishi MELSEC-A series Programming Manual

APPENDICES
APP − 40
MELSEC-A
APPENDIX 2 OPERATION PROCESSING TIME
The operation processing time of each instruction is shown in the tables on the
following pages.
The operation processing time differs depending on values in the source and
destination. Use the values in the tables as a guide to processing time.
(1) Processing time varies depending on the I/O control mode used with any
instruction operating on inputs or ontputs.
(2) The processing time for each instruction is shown for refresh mode.
The refresh processing time after END can be calculated as follows:
Sequence program processing time =
(instruction processing time) + (END processing time) + (refresh processing time)
Obtained from the list
END processing time =
(END instruction processing time) + (T/C processing time at END)
Refresh processing time =
• For AnN, A3V, A73 or A3N board
Refresh processing time =
Input points + Output points
16
• For A0J2H
Refresh processing time =
Number of modules used × 50 (µsec)
• For A2C
Refresh processing time =
12 × Input stations + 9.4 × Output stations +
11.6 × Total stations (µsec)
• For AnA, A2AS, AnU and QCPU-A (A Mode)
Refresh processing time =
Input points Output points
16 16
n
1 and n2 are as shown below.
n1 n2
For A2A, A2AS and A2U 5.2 5.0
For A3U, and A4U 4.8 4.65
For A2USH-S1 4.54 4.45
For Q02 5.07 4.80
For Q02H and Q06H 4.80 4.57
× 5.4 (µsec)
× n
1 +
× n
2 (µ sec)

Mitsubishi MELSEC-A series Specifications

General

Brand	Mitsubishi
Model	MELSEC-A series
Category	Controller
Language	English