Mitsubishi MT160D Instruction Book

FUEL FILTER ELEMENT REPLACEMENT
Fuel filter element is inserted in the filter body in the cup.
To replace the element, close the filter body cock, loosen
the ring nut and remove the cup. After removing the ele·
ment, clean it or replace it, as necessary. After installing
the cleaned or new element to the filter body, install the
cleaned cup to the body with care about "0" ring and then
tighten it enough. Loosen the air vent screw, open the cock,
fill the cup with fuel, and after confirming there is no more
air left, tighten the air vent screw, ensuring there is no fuel
leakage.
NOTE
In
case
the engine won't start, loosen the fuel pump air
vent screw and purge it.
CLEANING THE FUEL TANK
Cover for mud
Remove drain plug and clean the tank in the following
cases.
1. Every
600 hours of operation.
2. In case kerosene was entered for cleaning purpuse,
or water or dirt is in the tank.
-28 -
CHECKING THE ENGINE OIL LEVEL
The level is appropriate if it comes between two markings
at the end of gauge rod. The level should be checked
before starting the engine or 5 minutes after the engine
stopped.
NOTE
Check the oil level with the engine stopped in any
event.
ENGINE OIL REPLACEMENT
Remove the plug of the engine oil pan and completely
drain the used oil. Supply the specified oil up to the speci-
fied level. It
should be noted that dirty oil is more easily
discharged
when it is warm.
Replacing the engine oil should be carried out while the
tractor is placed horizontally.
..

Mitsubishi MT160D Specifications

General

Brand	Mitsubishi
Model	MT160D
Category	Tractor
Language	English