t
CLEANING THE HYDRAULIC OIL FILTER
O-ring
Filter screen
Remove the filter
at
the time of draining the transmission
case oil, and clean the filter.
Loosen
two
bolts and remove the hydraulic
oil
filter
under the right part of the transmission case.
The removed
oil
filter should be thoroughly cleaned
in
the
detergent solution.
If
the filter has been damaged, replace with a new one.
After installing the filter, make sure there
is
no
oil
leakage.
NOTE
1.
If
the transmission
oil
drained has
to
be
reused,
wipe clean the surrounding surfaces of the drain
plug before draining,
so
that
dust or dirt
will
not get into oil.
2.
Oil
replacement should
be
carried
out
in
every 200
hours under normal operating conditions.
If
oil
deteriorates excessively, replace it earl ier than
specified.
3. For installation of the
oil
filter make sure
that
the
pipe end of the filter
is
securely inserted into the
hole beside the suction pipe, and then install
the cover.
CHECKING THE 4-WD FRONT
AXLE
OIL
LEVEL
AND
ITS REPLACEMENT
CHECKING THE OIL LEVEL
Remove
oil
level
plug
to
check
that
oil
flows
out.
If
not,
add gear oil. For changing oil, refer
to
"LUBRICATION
TABLE".
Specified quantity: MT180HD - 2.5
Q (3/5 gal,
1/3
guart)
REPLACING THE OIL OF FRONT AXLE
o
Drain plug
Oil
level
plug
-35
-
To Next Page
Loading...
Need help?
General
