Mitsubishi MT160D Instruction Book

1. Remove drain plugs (3 locations) and let the oil flow
out.
2. Wrap the drain plugs with sealing tape and tighten it.
3. Enter new gear oil specified through filler port.
A CAUTION
Replace oil at the first 50m hours and in every 200
hou rs thereafter.
CLEANING THE RADIATOR SCREEN
1. Open the bonnet and remove the radiator screen.
2. After removing large dust, straw, etc. with hand, rinse
with clean water.
CLEANING THE RADIATOR
1. Check the radiator for clogging, and remove large dust,
straw, etc. if any, first with hand.
2. Blow with clean water to wash away remaining dust or
straw.
A CAUTION
Be careful not to damage the radiator since damaged or
deformed radiator will reduce the cooling efficiency.
CLEANING THE INSIDE OF RADIATOR
Clean radiator and engine coolant system with cleanser in
the following cases:
ell After 600 hours of operation
• Adding anti-freeze.
• Replacing coolant eliminating anti-freeze.
A CAUTION
For cleaning the radiator, read the instruction on
cleanser carefully, and observe the instruction.
CLUTCH PEDAL ADJUSTMENT
Clutch pedal free play is very important and it must be
always maintained to be correct. If there is no free play, the
clutch disc will wear quickly, while too much free play will
cause
difficult disengagement of the clutch even if the pedal
is fully depressed, resulting in hard gear shift.
• Amount of free play should be 20 to 30 mm (0.79 to
1.18 in.)
ell Adjust it in the following manner:
1) Remove the snap pin and clevis pin of clutch rod.
2) Adjust the amount of play by turning the joint.
Tu rn-in ......... Reduces the amount of play
Turn-out ........ Increases the amount of play
NOTE
This adjustment is important for maintaining the
clearance between the release lever and the release
bearing
to obtain a smooth gear shift and transfer all
the driving power to the transmission.
-36 -

Mitsubishi MT160D Specifications

General

Brand	Mitsubishi
Model	MT160D
Category	Tractor
Language	English