Mitsubishi S16R Series User Manual

4 FUEL
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
106
Pub. No. K29001-00320 Revision: 1
Fuel Quality Standard
Use a fuel which meets the requirements specified in the table below.
Table 4-2 Fuel Properties Table (1/2)
Item Recommended limit Service limit Remark
Flash point
Diesel fuel 50°C [122°F] or
higher
50°C [122°F] or higher
(depending on the laws
and regulations for han-
dling fuel)
JIS K 2265:2007
ISO 3679
ISO 2719
Distillation
Properties
Initial boiling
point
170°C [338°F] or higher 170°C [338°F] or higher
JIS K 2254:1998
ISO 3405
90% distillation
temperature
330 to 380°C
[626 to 716°F]
330 to 380°C
[626 to 716°F]
Pour point (PP)
Lower than ambient tem-
perature by 6°C [10.8°F] or
more
Lower than ambient tem-
perature by 6°C [10.8°F] or
more
JIS K 2269:1987
ISO 3016
Cloud point (CP)
Ambient temperature or
below
Ambient temperature or
below
Cold filter plugging point
(CFPP)
Lower than the ambient
temperature by 3°C [5.4°F]
or more
Lower than the ambient
temperature by 3°C [5.4°F]
or more
JIS K 2288:2000
ISO 3015
Carbon
residue
content
10% residual
oil
0.4 weight% or lower 1.0 weight% or lower
JIS K 2270:2000
ISO 6615
ISO 10370
Cetane number 45 or higher *1 45 or higher *2 JIS K 2280:1996
Cetane
Index
(New method) 45 or higher 45 or higher
ISO 5165
ISO/DIS 4264
Kinetic viscosity
2.0 mm
2
/s or higher at
30°C [86°F]
8.0 mm
2
/s or lower at 50°C
[122°F]
2.0 mm
2
/s or higher at
30°C [86°F]
8.0 mm
2
/s or lower at 50°C
[122°F]
JIS K 2283:2000
ISO 3104
Sulfur content 0.2 weight% or lower
1.0 weight% or lower *2 *3
(Shorten the engine oil
change intervals.)
JIS K 2541:1996
(The content amount
as low as that of
regular light oil is
desirable.)
ISO 4260, ISO 8754
Water content and sediment 0.1 volume% or lower 0.1 volume% or lower
JIS K 2275:1996
ISO 3733
Ash content 0.01 weight% or lower 0.03 weight% or lower
JIS K 2272:1998
ISO 6245
Copper
corrosion
50°C [122°F],
3 Hr
Discoloration = Copper
plate No. 3 or less
(deep discoloration)
Discoloration = Copper
plate No. 3 or less
(deep discoloration)
JIS K 2513:2000
ISO 2160
Density 15°C [59°F]
0.83 to 0.87 g/cm
3
[51.82 to 54.31 lb/ft
3
]
0.80 to 0.87 g/cm
3
[49.94 to 54.31 lb/ft
3
]
JIS K 2249:1995
ISO 3675

Mitsubishi S16R Series Specifications

General

Brand	Mitsubishi
Model	S16R Series
Category	Engine
Language	English