8 INSPECTION AND MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
133
Pub. No. K29001-00320 Revision: 1
Inspection and Maintenance -
Prepare
Before inspection and maintenance work, be sure
to prepare as follows according to the content of
inspection and maintenance:
• Devices and equipment outside the
scope of our supply are included in the
facility.
For the details, refer to such a document
as the specification sheet prepared by
the generator supplier.
• For the devices and equipment outside
the scope of our supply, refer the
corresponding manual of the generator
and the supplier's operation manual.
Inspection and Maintenance -
Prepare (with Engine Switched ON)
1 Post a sign "Do Not Operate", for
example, on the operation panel of
the generator and let the other
operators not to operate.
"Starting and Stopping Devices
Installed during Manufacturing the
Generator" (→ Page 87)
Make sure that dripped oil, parts,
tools or other things are not left on the
floor around the engine. Always
maintain cleanliness and tidiness.
* Otherwise, a tumbling accident may occur.
* Wear proper personal protective equipment for
the work.
Watch your step during inspection
and maintenance work.
* Otherwise, a tumbling accident or a falling
accident may occur while working on the floor
panel or other high positions.
* The floor could be extremely slippery due to
spilt oil. Thoroughly wipe off oil on the floor and
the sole of your shoes.
* Install a stable scaffold as required.
Cover the disconnected pipes or
joints and their openings properly so
that dusts or other foreign objects will
not enter into them.
* Otherwise, the devices may be damaged.
The engine must be inspected and
maintained only by qualified persons
who have received a required training
or on-site instructions, or done so
under the mentorship of a person who
have completed our training course.
* Otherwise, serious personal injury or damage to
the devices may occur.
When working on the upper part of the
engine and other hard-to-reach
places, use a stable work platform.
* Do not stand on an old stool or parts box.
Otherwise, it may result in personal injury. In
addition, do not put any unnecessary objects on
a work platform.
While inspecting and maintaining, do
not put your hand in a gap between
the connecting rod, crankshaft,
timing gear or others and the
crankcase.
* Otherwise, you may be stuck and injured.
While operating the engine, stay away
from the moving parts.
* Otherwise, you may cut your hand by the
rotating parts, or be caught in them and injured.
Make sure that the tools to be used
are not damaged.
* Using a damaged tool or a wrong-size tool may
cause personal injury or damage to the devices.
Check and calibrate measurement
equipment periodically.
* Using uncalibrated measurement equipment
may cause damage to the devices or
performance degradation of them.
To Next Page
Loading...
Need help?
General
