Charging Method
This chapter describes the methods you use to charge your
radio.
4.1
Charging Stand-Alone Battery
1 Align the raised tab on each side of the battery with
the corresponding groove on each side of the
charger pocket.
2 Press the battery toward the rear of the pocket.
3 Slide the battery into the charger pocket, ensuring
complete contact between the charger and battery
contacts.
When the battery is in the pocket, the charger
indicates the Battery Level status as shown in
Charger LED Indication on page 20 table. The red
LED blinks to indicate that the battery is charging
rapidly. The LED changes to a steady green light to
indicate that the battery is nearly or fully charged.
4.2
Charging with the Drop-In Tray
Single Unit Charger
The Single Unit Charger (SUC) is an optional accessory
device.
NOTICE:
Turn off the radio before charging, and fully charge
the battery before first use. It is best to charge at
room temperature.
1 Place the SUC on a flat surface.
English
17
To Next Page
Loading...
Need help?
General
