PROGRAMMING
FEATURES
English
50
PROGRAMMING BUTTONS
You can map any channel to either button B or
C as a preset channel. To enable, enter
’Programming Mode’ and choose the channel
you want to set as preset channel using the /
buttons. Once you have selected your
channel, press and hold the B or C button for
2 – 3 seconds.
A short press of either preset button (B and C)
will play a good key chirp.
When scanning, a short press of either preset
button will change the home channel to the
preset channel. The radio will display FREQ/PL
and will continue to scan from the new home
channel.
EDITING CHANNEL ALIAS NAME
To edit a channel’s alias, turn ON the radio and
press and hold the PTT button and the
button for 3 seconds. Upon entering the
‘Channel Alias Mode’, the radio will generate a
special beep. You will see the current channel
alias name and channel number blinking as
follows:
Choose the channel number you want to edit
by pressing the / buttons. Once you have
selected the channel number, press the PTT
button or MENU to start editing the channel
name. If you want to exit the Channel Aliasing
Mode long press the PTT button.
• A cursor will blink at the end of the channel
name. Use button B to move the cursor to the
left. If you're in the first character, the radio will
give you a bonk tone. Whenever you press
BRUS_display.book Page 50 Monday, January 16, 2012 5:28 PM
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
To Next Page
Loading...
Need help?
General
