PROGRAMMING
FEATURES
English
56
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the ‘cloning’
mode.
Note: If cloning fails please refer to “What to do if
cloning fails” on page 57.
Further details on how to clone units are
explained in the instructions sheet provided
with the MUC.
When ordering the MUC please refer to P/N
RLN6309. See accessories details on
“Chargers” on page 86.
Notes:
• Paired target radios and source radios must
be of the same type in order for cloning to run
successfully.
• (*) MUC pockets numbers should be read
from left to right with the Motorola logo facing
front.
Cloning Radios using the Radio to Radio
(R2R) Cloning Cable (optional accessory)
Operating Instructions
Source Radio: Radio to be cloned.
Target Radio: Radio to which the configuration
of the “Source Radio” will be copied (cloned).
1. Before beginning the cloning process, make
sure you have:
• A fully charged battery on each one of the
radios.
• Two Single Unit Chargers (SUC).
BRUS_display.book Page 56 Monday, January 16, 2012 5:28 PM
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
To Next Page
Loading...
Need help?
General
