Motorola RMU2040 User Manual

PROGRAMMING
FEATURES
English
43
•
Example of Programming Auto-Scan
Auto-Scan is the third Programming Mode
and can be set to either ON or OFF on a
particular channel.
To set Auto-Scan to ON:
•
Enter into advanced Configuration Mode and
select the desired channel.
•
Short press the PTT button three times to enter
Auto-Scan Programming Selection Mode. The
radio will announce "Auto-Scan" and current
setting (Enabled or Disabled).
•
Short press the SB1 or SB2 buttons to
toggle Enabled/Disabled for the Auto-Scan
feature on the selected channel.
Example of Programming Active Channels
Active Channels is the last Programming Mode and
It allows you to modify the number of active channels
the radio will be programmed to support.
To set Active Channels:
Enter Programming Mode and select the
desired channel
Short press the PTT button Four times to enter
Active Channels Programming Selection Mode.
The radio will announce "Active Channels" and
current value.
Short press the SB1 or SB2 buttons until you
hear the number of channels desired.
•
•
Long press the PTT button. LED Indicator will
show a green heartbeat to indicate “Idle” state.
•
Long press the PTT button to exit
Programming Mode or turn radio OFF.
•
Long press the PTT button. LED Indicator will
show a green heartbeat to indicate “Idle” state.
•
Long press the PTT button to exit
Programming Mode or turn radio OFF.
•
•

Motorola RMU2040 Specifications

General

Frequency Band	UHF
Frequency Range	450-470 MHz
Channels	4
IP Rating	IP54
Range	Up to 250, 000 sq. ft. / 20 floors
Weight	8.6 oz (with battery)
Dimensions	4.5 x 2.2 x 1.5 in (115.6 x 57.6 x 38.6 mm)