National Instruments 6368 User Manual

© National Instruments | 1-7
X Series User Manual
Mounting NI USB X Series Devices
(NI USB-63
xx Screw Terminal/Mass Termination Devices) You can use your NI USB
X Series device on a desktop, mount it to a wall or panel as described in the
Panel/Wall
Mounting
section, or mount it to a standard DIN rail as described in the DIN Rail Mounting
section.
Panel/Wall Mounting
Complete the following steps to mount your NI USB X Series device to a wall or panel using the
USB X Series mounting kit (part number 781514-01 not included in your USB X Series device
kit). Refer to Figure 1-3.
1. Use three #8-32 flathead screws to attach the backpanel wall mount to the panel/wall.
Tighten the screws with a #2 Phillips screwdriver to a torque of 1.1 N · m (10 lb · in.).
Figure 1-3. Using the USB X Series Mounting Kit on a Wall or Panel
2. Place the USB X Series device on the backpanel wall mount with the signal wires facing
down and the device bottom sitting on the backpanel wall mount lip.
3. While holding the USB X Series device in place, attach the front bracket to the backpanel
wall mount by tightening the two thumbscrews.

National Instruments 6368 Specifications

General

Brand	National Instruments
Model	6368
Category	Data Loggers
Language	English