4.2.4 Pads
Pads
Here's an overview of what the pads do in each mode:
HOTCUE mode
During playback, pressing in an inactive pad sets a cue point. The pad lights up and the cue
point is automatically assigned to this pad. Pressing that pad again let jump back the playhead
to the cue point just defined.
FREEZE and Slicer Mode
In Freeze mode, TRAKTOR takes the playhead position, adds the number of bars set as loop
size and splits this section of a track into eight equally sized slices. These are then mapped to
the pads. Press a pad to start playback from that slice.
While in Freeze mode, you can access Slicer mode. This is how Slicer mode is different from
Freeze mode:
▪ In Slicer mode, holding a pad will infinitely loop the corresponding slice.
▪ In Slicer mode, holding two pads will loop the range between the start of one pad and the
end of the second.
Hardware Reference
The Deck
TRAKTOR KONTROL S5 - Manual - 158
To Next Page
Loading...
Need help?
General
Weight and Dimensions
