246
• To pair Bluetooth
adapter with mobile
phone
DT830 Series/DT430 Series and a mobile phone
can be connected through Bluetooth
by pairing
the Bluetooth
adapter with the mobile phone.
For the terminal, a maximum of 8 pairing informa-
tions can be saved. However, the most recently
connected mobile phone is connected through
Bluetooth
first.
STEP 1: Confirm that Bluetooth
feature is OFF
(Connect key lamp turns off).
STEP 2: Hold down the Connect key for over eight
seconds to enable pairing mode. When
the Connect key has been kept pressed
three or more seconds, the Connect key
lights red. However, to enable pairing
mode, continue to press the Connect key
until it lights alternately red and green.
STEP 3: The mobile phone scans for the
Bluetooth
device, pairs itself with the
Bluetooth
adapter, and connects to the
terminal. For details of this procedure,
refer to the manual of your mobile phone.
• To enable Bluetooth
feature
STEP 1:Press the Connect key several seconds
(from three or more seconds to less than
eight seconds) when the Bluetooth
feature is OFF (the Connect key is turn
off).
STEP 2: The Connect key lights red, and the
Bluetooth
feature turns ON.
Note:
If the terminal is not operated for three and a half
minutes after terminal enters into pairing mode, the
Bluetooth
feature will be enabled.
Note:
If the terminal and mobile phone are already
paired, the terminal and the mobile phone can be
connected through Bluetooth
only operating with
the mobile phone.
Note:
When the terminal starts up, the Bluetooth
feature
will be automatically ON.
Note:
When the Bluetooth
feature is ON, the Bluetooth
connection is made with the most recently
connected mobile phone.
Note:
If you press the Connect key for eight seconds or
more, the terminal status will be Pairing mode
(Flashing alternately Red and Green every one
second).
To Next Page
Loading...
Need help?
General