Nedap TRANSIT Entry User Manual

TRANSIT ENTRY | INSTALLATION GUIDE
Content
2/30
CONTENT
1 INTRODUCTION _______________________________________________________ 3
1.1 PRODUCT DESCRIPTION __________________________________________ 3
1.2 OPTIONAL CARD TECHNOLOGY READER INTERFACE __________________ 3
2 INSTALLATION ________________________________________________________ 4
2.1 SAFETY PRECAUTIONS ___________________________________________ 4
2.2 MOUNTING INSTRUCTIONS _______________________________________ 4
2.3 ADJUSTABLE MOUNTING BRACKET _________________________________ 5
2.4 OPENING THE SERVICE COVER ____________________________________ 6
2.5 INSTALLING AN OPTIONAL INTERFACE BOARD _______________________ 6
2.6 AVAILABLE INTERFACE BOARDS ___________________________________ 6
3 CONNECTIONS ________________________________________________________ 8
3.1 CABLE CONNECTIONS ____________________________________________ 8
3.2 WIRE CONNECTIONS _____________________________________________ 9
3.3 POWER SUPPLY _________________________________________________ 9
3.4 COMMUNICATION ______________________________________________ 10
3.4.1 RS232 CONNECTION _____________________________________ 10
3.4.2 RS422 CONNECTION _____________________________________ 11
3.4.3 WIEGAND, MAGSTRIPE, BARCODE CONNECTION ______________ 12
3.4.4 USB CONNECTION ________________________________________ 13
3.5 DIGITAL I/O ____________________________________________________ 14
3.5.1 RELAY OUTPUT __________________________________________ 14
3.5.2 READ DISABLE INPUT _____________________________________ 15
3.5.3 GENERAL PURPOSE INPUTS ________________________________ 16
3.5.4 GENERAL PURPOSE OUTPUTS ______________________________ 17
3.5.5 TAMPER SWITCH _________________________________________ 18
3.6 SPECIAL CONNECTIONS _________________________________________ 19
4 DIP SWITCH SETTINGS _________________________________________________ 20
5 LED INDICATIONS ____________________________________________________ 21
6 FREQUENCY SELECTION _______________________________________________ 22
7 READ RANGE CONTROL (SQUELCH) _____________________________________ 23
7.1 PRINCIPLE _____________________________________________________ 23
7.2 READ RANGE ADJUSTING ________________________________________ 23
8 IDENTIFICATION ______________________________________________________ 24
8.1 STANDARD OPERATING PROCEDURE ______________________________ 24
8.2 USING THE MTR MODULE ________________________________________ 24
9 FIRMWARE UPGRADE _________________________________________________ 25
A TECHNICAL SPECIFICATIONS ___________________________________________ 26
B PART NUMBERS ______________________________________________________ 27
C FCC / IC STATEMENT __________________________________________________ 28
D DISCLAIMER _________________________________________________________ 29
E DOCUMENT REVISION _________________________________________________ 30

Nedap TRANSIT Entry Specifications

General

Brand	Nedap
Model	TRANSIT Entry
Category	Rfid Systems
Language	English