Services
The Service Control List (SCL) allows you to enable or disable your Local Area Network (LAN) or Wide Area Network (WAN) services
by ticking the checkbox as illustrated below. The following access services are available: FTP, HTTP, ICMP, SAMBA, SNMP, SSH,
TELNET, and TFTP. Click the Apply/Save button after making any changes to continue.
Update Firmware
The following screen appears when selecting the Update Software option from the Management menu. By following this screen’s
steps, you can update your modem’s firmware. Manual device upgrades from a locally stored file can also be performed using the
following screen.
1.
Obtain an updated software image file.
2.
Enter the path and filename of the firmware image file in the Software File Name field or click the Browse button to locate
the image file.
3.
Click the Update Software button once to upload and install the file.
Reboot
This option reboots the NF10W.
NOTE 1: It may be necessary to reconfigure your TCP/IP settings to adjust for the new configuration. For example, if you
disable the Dynamic Host Configuration Protocol (DHCP) server you will need to apply Static IP settings.
NOTE 2: If you lose all access to your web user interface, simply press the reset button on the rear panel for 3 seconds to
restore default settings.
To Next Page
Loading...
Need help?
General
