NETGEAR FS 726 User Manual

installation 4-4
Connecting Devices to the Switch
The following procedure describes how to connect devices to the switch’s RJ-45 ports.
When attaching devices to an FS726 or an FS750, the switch’s support for Auto
Uplink technology allows you to attach devices using either straight-through or
crossover cables (for more information about Auto Link‘ technology, refer to "Auto
Uplink " on page 12).
7. Connect each device to an RJ-45 network port on the switch’s front panel (see
Figure 4-2).Use Category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated
with an RJ-45 connector to make these connections.
Figure 4-2.Connecting Devices to the Switch
Note: Ethernet specifications limit the cable length between the switch and the
attached device to 100 m (328 ft).
Front Panel of the Model FS726 or Model FS750 Switch
(Model FS726 shown)

NETGEAR FS 726 Specifications

General

Brand	NETGEAR
Model	FS 726
Category	Network Router
Language	English