NETGEAR R7300DST User Manual

13
Connect Devices to the DST Adapter
You can connect devices to the DST adapter using a wired Ethernet
connection, a WPS connection, or a WiFi connection.
Connect to the DST Adapter Using Ethernet
¾ To connect devices to the DST adapter using an Ethernet
connection:
Use an Ethernet cable to connect the Ethernet port on your
device to the Ethernet port on the DST adapter.
Connect to the DST Adapter Using WPS
¾ To connect devices to the DST adapter using WPS:
1. Press and hold the WPS and DST Router Sync button on the
DST adapter.
The WiFi LED on the DST adapter blinks.
2. Within two minutes, press the WPS button on your WiFi device
(such as a computer, tablet, or smartphone).
When the WiFi LED stops blinking, your WiFi device is
automatically connected to the DST adapter and you can access
the Internet from your WiFi device.
Note: Make sure that your WiFi device is in the same room as
the DST adapter that you are connecting to.

NETGEAR R7300DST Specifications

General

Brand	NETGEAR
Model	R7300DST
Category	Network Router
Language	English