MERCURY 310 Controller
User Guide
33
MX5096 Rev. C ©2022
Thank you for choosing a HySecurity | Nice automatic gate opener system! This user guide provides the following
information to the end user:
’ Important safety information
’ Description of the user controls
’ Manual linear actuator release instructions
’ Error and Stop codes to aid in troubleshooting
Operation is the same for both dual and single gate installations. There are other features that may have been
installed, such as loop sensors or remote control devices, so it is important for you to refer to your professional
automated gate installer for important information regarding such features.
Contact Information:
Visit https://support.hysecurity.com/hc/en-us for installation manuals, replacement part instructions, part diagrams
and more. Qualied Nice | HySecurity distributors are experienced and trained to assist in resolving installation
problems.
For the name of a qualied distributor near you, call Nice | HySecurity at 800-321-9947. *Before contacting your
distributor or Nice | HySecurity Technical Support, obtain the serial number of your operator.
NOTICE:
The information in this user guide is provided under the assumption that the gate system has been installed
and set up by an automated gate installation professional aware of all necessary safety and mechanical
requirements.
It is very important to heed safety warnings, as an improperly operated gate system can cause serious injury
or death to persons or animals. READ ALL SAFETY WARNINGS AND CAUTIONS!
NOTICE:
The SolarBOX 310 control box features a lock and key for the external gate
control button on the chassis. The cover may also be secured with a padlock
if your installer was instructed to do so.
Ensure that the installer hands you the keys and shows you how to use
them. Store them in a secure place.
1. INTRODUCTION
WARNING
Disconnect the operator from power (both DC/Solar & Battery) when installing
any accessory or external entrapment sensor.
To Next Page
Loading...
Need help?
General
