ENGLISH – 15
PROGRAMMING
7
7 PROGRAMMING
There are 3 buttons on the control unit:
p
,
o
and
q
(“Figure
23”) which can be used both to command the control unit during
the testing phase and to programme the available functions.
FUSE
L1L2L3L4L5L6L7L8
LED
FUSE
RECEIVER
L1 ... L8
23
The available programmable functions are grouped into two
levels and their operating status is signalled by eight LEDs “L1
... L8” located on the control unit (LED lit = function enabled;
LED off = function disabled).
7.1 USING THE PROGRAMMING BUTTONS
p
The button allows for commanding the door opening
movement, or shifting the programming point upwards.
o
Button used to stop a manoeuvre
If pressed for more than 3 seconds, it allows for entering
the programming mode.
q
The button enables the user to close the door or shift the
programming point downwards.
During the manoeuvre, whether opening or closing is irrele-
vant, all the buttons perform the STOP function and stop the
motor’s movement.
To Next Page
Loading...
