Nice SO2000 User Manual

24 – ENGLISH
Table 16
LEDS ON THE CONTROL UNIT BUTTONS
LED 1 Description
OFF
During normal operation, this indicates that “Automatic Closing” is disabled.
On
During normal operation, this indicates that “Automatic Closing” is active.
Flashes
Function programming in progress.
With the motor stationary, if it ashes individually it means that the encoder position is in the Low Overrun position
(position below or equal to 5%). Adjust the position then rerun the position search procedure.
If it ashes together with “L2”, it means that the device learning phase must be carried out (refer to the “Device
learning” paragraph).
LED 2 Description
OFF
During normal operation, it signals that the “Close after photo” mode is not active.
On
During normal operation, it signals that the “Close after photo” mode is active.
Flashes
Function programming in progress.
If it ashes together with “L1”, it means that the device learning phase must be carried out (see the “Device
learning” paragraph)
LED 3 Description
OFF
During normal operation, this indicates that “Always Close” is not active.
On
During normal operation, it signals that “Always close” is active.
Flashes
Function programming in progress.
If it ashes together with L4, it means that the door opening and closing positions must be learned (refer to the “
Learning of the door opening and closing positions” paragraph).
LED 4 Description
OFF
During normal operation, it signals that the “Stand-by” mode is not active.
On
During normal operation, it signals that the “Stand-by” mode is active.
Flashes
Function programming in progress.
If it ashes together with L3, it means that the door opening and closing positions must be learned (refer to the “
Learning of the door opening and closing positions” paragraph).
LED 5 Description
OFF
During normal operation, it indicates that “Long reversal” is not enabled.
On
During normal operation, it indicates that “Long reversal” is enabled.
Flashes
Function programming in progress.
LED 6 Description
OFF
During normal operation, it signals that the “Pre-ashing” mode is not active.
On
During normal operation, it signals that the “Pre-ashing” mode is active.
Flashes
Function programming in progress.
LED 7 Description
OFF
During normal operation, it indicates that “Sensitivity” is not enabled.
On
During normal operation, it indicates that “Sensitivity” is enabled.
Flashes
Function programming in progress.
LED 8 Description
OFF
During normal operation, it indicates that the installation includes 1 motor.
On
During normal operation, it indicates that the installation includes 2 motors.
Flashes
Function programming in progress.
With the motor stationary, if it ashes individually it means that the encoder position is in the High Overrun position
(position above or equal to 95%). Adjust the position then rerun the position search procedure.

Nice SO2000 Specifications

General

Brand	Nice
Model	SO2000
Category	Garage Door Opener
Language	English