141
Q
Copying Pictures to the Computer
Before proceeding, be sure you have installed ViewNX-i (0 140).
1
Connect the USB cable.
After turning the camera off and ensuring that a memory
card is inserted, connect the supplied USB cable as shown
and then turn the camera on.
A
Use a Reliable Power Source
To ensure that data transfer is not interrupted, be sure the camera
battery is fully charged.
A
Connecting Cables
Be sure the camera is off when connecting or disconnecting inter-
face cables.
Do not use force or attempt to insert the connectors at
an angle.
D
During Transfer
Do not turn the camera off or disconnect the USB cable while trans-
fer is in progress.
D
USB Hubs
Transfer may not proceed as expected if the camera is connected
via a USB hub or keyboard.
To Next Page
Loading...
Need help?
General
